Steering Components

This 3/8" bearing 17mm billet spindle assembly comes with everything you need to replace the left spindle on your Brava chassis. It comes complete with the spindle, tie rod end with hardware, wheel spacers, castle nut and safety clip. This package should have what you need to get you rolling again.

These anodized spindle spacers are designed to be used with 17mm spindle shafts. They come in a 5mm, 10mm and 20mm lengths. Most modern applications use three of each per spindle. Most modern applications require 2 long spacers, 1 medium spacer and 2 short spacers.

Machined from billet 6061-T6 aluminum, this TruSpeed steering wheel hub fits a 3/4" diameter shaft (standard on all Margay Brava karts). Two mounting positions allow the driver to fine tune the steering wheel postion for maximum performance. The angled hub kicks the top of the wheel 8 degrees closer to the driver. Some drivers prefer a more vertically oriented wheel, claiming that it reduces fatigue and arm pump. Steering wheel mounting holes are tapped for M6x1 fasteners.

This 3/4" diameter tubular steering shafts are used on the more modern Margay chassis. They feature 3 position steering ackerman with a center hole and outside holes.

Adjustable Caster pill, 3/8 kingpin, full offset-Utilize to change caster and camber on all AC compatible spindle hangers that feature a 3/4" mounting hole. Installing a single pill allows you to change caster or camber by up to 1.5 degrees. Installing a full offset pill in the top and bottom of the sppindle hanger allows you to change caster by up to 3 degrees.

Adjustable caster / camber pill that allows the spindle to sit at its factory settings. These pills are centered, and can only be used with a 3/8" kingpin bolt.

Margay Racing's new billet aluminium steering block fairing mount combines cutting edge technology with lightweight performance. This steering block is available for American manufactures (3/4") and European manufactures (20mm).