Available in 10, 12, and 15 degrees for both the right and left hand sides and feature a 5/8" shaft and internal bearings for se with a 3/8" kingpin.
These were used on virtually all Margay karts produced between 1980 and 1992.
When ordering replacement parts for your kart, check your existing spindle to determine the correct KPI (King Pin Inclination) angle. Spindles should have a 10, 12 or 15 stamped on the end of the control arm. If there is no number, the spindle is 15 degrees. If your kart has a gusset on the lower steering support with 3 quarter-sized holes in it, the correct KPI angle should be stamped there as well. Again, if there is no number, it is a 15 degree kart and requires 15 degree spindles.
Virtually all karts built prior to 1980 were 15 degree KPI karts. Those karts originally utilized 15 degree spindles featuring a 1/2" diameter kingpin. These 15 degree spindles can be adapted for use with those older karts by utilizing a 'Spindle Adapter Kit'.
Please specify an angle and side when ordering.
Please note, 10 degree spindles are currently out of stock.
|
